Install the Remote Desktop plugin

1.To start the installation, on the appropriate Remote Desktop Access machine, run the supplied .EXE file. The installer will run several prerequisite checks as was done during the Authentication Server installation.

2.When prompted, select the check box next to Remote Desktop and click Next.

installer_remote_desktop-component-selected

3.Enter the connection information of the Authentication Server when prompted (applies to standalone installation mode). Click Next.

installer_authentication-server-access

4.If the connection to Authentication Server is successful, and the server certificate has been verified, select check box Add certificate with this thumbprint to machine store if available. Click Next.


note

Correct failures reported by the prerequisite checks

Prerequisite checks will run to verify the ESA Remote Desktop plug-in can be installed. Any failures must be corrected before installation can proceed.

5.Go through the remainder of the steps as prompted by the installer and close the installer when complete.