ERA Virtual Appliance Management Console

After you have successfully deployed the ERA VA, open Virtual Machine's terminal window. You'll see a basic information screen of your ERA VA and its status. This is the main ERA VA screen. From here, you can log into ERA VA Management Console (also know as management mode) by pressing Enter key on your keyboard. To enter the management mode, type your password that you specified during ERA VA configuration and press Enter twice. In case you have not configured your ERA VA yet, you can use default password eraadmin to access management mode.

Once you are logged into ERA VA Management Console, the following configuration/management items are available:

Set Static IP address

Enable/Disable Webmin interface

Backup database

Restore database

Reset after snapshot revert

Pull database from other server

Change VM password

Change database password

Rejoin domain

Configure domain

Factory reset

validation-status-icon-warning IMPORTANT

Presence of the items above may vary depending on ERA VA implementation phase and configured Appliance type.

Restart system - if you want to reboot your ERA VA

Shut down system - if you want to shut down your ERA VA

Lock screen - you should lock the screen to prevent other people from using your ERA VA and accessing its files. You can also use an Esc key to lock the screen which is even quicker. Management mode will close and you'll see the main ERA VA screen.

Exit to terminal - use it if you want to access operating system's terminal. It will close ERA VA Appliance Management Console and enters the terminal. In order to get from the terminal back to the main ERA VA screen, type exit and press Enter key (you can also use logout command which has the same effect).